₨ 259 ₨ 364
The GL-12 solderless breadboard is designed for temporary electronic circuits, classroom experiments and Arduino-compatible prototyping. Components and jumper wires plug into internal spring contacts, allowing a circuit to be assembled, tested and changed without soldering.
The board can be used with compatible resistors, LEDs, diodes, transistors, capacitors, integrated circuits and solid-core jumper wires. Before applying power, check the internal row and rail connections with a continuity tester, especially when using distribution rails that may be split.
Use compatible male-to-male jumper wires to connect development-board headers and the breadboard contacts.
Explore more breadboards and prototyping boards from Robonation Pakistan. For layout and wiring fundamentals, review the SparkFun breadboard guide.
The listing specifies 840 solderless tie points: 640 terminal-strip points and 200 distribution-strip points.
No. Components and jumper wires are inserted into the spring contacts for temporary circuit prototyping without soldering.
The listed supported wire range is approximately 20 to 29 AWG. Solid-core jumper wire is generally easiest to insert.
Yes. The listing specifies self-adhesive backing for optional mounting on a clean, suitable surface.
Rail continuity can vary by breadboard version. Check each distribution rail with a continuity tester before applying power, especially where the printed rail marking appears divided.
Dimension : 10×22 cm / 3.9×8.6 inch (W x L)
Hole ( row x column ) : 80 x 38
Material : glass fiber FR4
Metal :Tin-plate
Thickness : approx. 1.6mm
Hole Pitch : approx. 2.54 mm
Hole Diameter : approx. 1 mm
Mounting Hole Diameter : approx. 3 mm
Color : green basic,silver tone
1. Suggested only if you know how to etch PCBs with FeCl3.
2. You must use gloves while etching with FeCl3 as it may cause irritation to your skin.
3. Mix etchant in water, do not drop water over the etchant.
4. Do an etching procedure in open space so any chemical gas produced during the process can dissipate in the air easily.
5. Put etchant+water solution in the plastic box only.
Mix the solvent with warm water and your etching solutions is ready. You can also store and re-use the solution.
Note: High corrosive chemical, caution!! Harmful to skin and eyes. Please make sure all precautionary measures are in place like hand gloves, glasses, etc.
24C16 
TL082 TL082CN Operational Amplifier OPA IC in DIP-8 Package 
Potentiometer 22K OHM 
IN4002 Diode 
DB3 - DIAC DO-35 Glass diode 
There are no reviews yet.