Arduino UNO R3 DIP development board with ATmega328P controller and USB programming cable. It provides 14 digital I/O pins, six analog inputs, 5V operation and a familiar UNO layout for electronics learning, robotics, automation and sensor prototypes. This listing is for the board and cable only.
₨ 1,579 ₨ 3,120
The Arduino UNO R3 DIP is a practical ATmega328P development board for students, makers and engineers building robotics, automation and embedded-electronics projects. The removable DIP-package controller distinguishes this version from an SMD UNO, while the familiar UNO R3 pin layout supports common shields, sensors and learning examples.
This board is suitable for LED control, sensor reading, small robots, home-automation prototypes and introductory embedded programming. Check the USB interface and board revision if a computer driver is required, and always match connected modules to the correct logic and supply voltage.
For a breadboard prototype, pair this board with 40-piece male-to-male jumper wires and a GL-12 solderless breadboard.
Browse more Arduino boards in Pakistan from Robonation Pakistan. For board layout and technical limits, review the official Arduino UNO Rev3 documentation.
The board is based on the ATmega328P microcontroller and operates at 5V with a 16MHz clock.
This listing includes the Arduino UNO R3 DIP development board and a USB programming cable. Other starter-kit components are not included unless separately stated.
On a DIP version, the main ATmega328P is installed in a removable through-hole package. On an SMD version, the controller is soldered directly to the board.
Yes. Connect its headers to a separate solderless breadboard with compatible jumper wires, and confirm the supply and logic voltage required by every connected component.
The familiar UNO R3 layout supports many compatible sensors and shields. Check each accessory's pin use, logic voltage and current requirements before connecting it.
5V single-channel relay module for Arduino-compatible and automation projects. The listed trigger type is high-level input, with at least 4mA drive current. It provides COM, normally open (NO) and normally closed (NC) relay contacts and an on-board status LED. Approximate size: 41 × 16 × 16mm; approximate weight: 12g.
Two-way infrared obstacle-detection module for Arduino-compatible robots, line-following experiments and automation prototypes. Its reflective IR sensing can be adjusted for the application, but reliable range depends on target colour, surface texture, angle and ambient light. Calibrate both sensing paths in the final installation environment.
This is the SMD RGB LED Common Cathode Module, These module has 3 separate LEDs the Red, Green and Blue which can be individually driven by applying a voltage to the appropriate module pin this example code is uses the Arduino analogWrite(PWM) function to cycle through the full possible output colors this smd led module is capable of producing a rainbow color scheme.
Compact Arduino Nano V3-compatible development board for breadboards, robotics and embedded prototypes. This listing describes a 5V, 16MHz Nano-style board with 14 digital I/O pins, six PWM outputs and eight analog inputs. Confirm the installed controller, USB connector and driver requirements on the supplied board revision.
24C16 
TL082 TL082CN Operational Amplifier OPA IC in DIP-8 Package 
Potentiometer 22K OHM 
There are no reviews yet.