-
×
RF 315/433 Transmitter/Receiver Module
1 × ₨ 299
Subtotal: ₨ 299
-33%
Communication Modules, RFID
125KHz EM18 reader module EM-18 build in coil antenna
- Operating voltage of EM-18: +4.5V to +5.5V
- Current consumption:50mA
- Can operate on LOW power
- Operating temperature: 0C to +80C
- Operating frequency:125KHz
- Communication parameter:9600bps
- Reading distance: 10cm, depending on TAG
- Integrated Antenna
₨ 1,499 ₨ 2,236
125KHz EM18 reader module EM-18 build in coil antenna
This is a great little RFID Reader Module from Innovations, similar to the ID models (the difference being no silicone protection on the back). If you need an inexpensive way to get started with RFID, this is a great little module. Just power the module, and it will read any RFID card within range.
It will output the card’s ID in a serial string, which can easily be read by any microcontroller. The spacing on the pins is 2.54 mm, which means the module will directly fit on a breadboard.
Based on 0 reviews
Be the first to review “125KHz EM18 reader module EM-18 build in coil antenna”
Related products
-
Arduino & IOT Boards, Communication Modules, Module, RF Modules
HW-237 2.4GHz NRF24L01+PA+LNA SMA Wireless Transceiver Module with Antenna
Arduino & IOT Boards, Communication Modules, Module, RF ModulesHW-237 2.4GHz NRF24L01+PA+LNA SMA Wireless Transceiver Module with Antenna
- Voltage: 3-3.6V (recommended 3.3V) V.
- Maximum output power: +20dBm.
- Emission mode current(peak): 115mA.
- Receive Mode Current(peak): 45mA.
- Power-down mode current: 4.2uA.
- Sensitivity 2Mbps mode in received: -92dBm.
- Sensitivity 1Mbps mode in received: -95dBm.
- PA gain: 20DbLNA gain: 10Db.
- Sensitivity 250kbps mode in received: -104dBm.
- Operating Range: 1 km
- LNA Noise figure: 2.6 Db.
- Antenna Gain (peak): 2Dbi.
- 2MB rate (Open area): 520m.
- 1MB rate (Open area): 750m.
- 250Kb rate (Open area): 1100m.
- Interface: SPI.
SKU: n/a -
Communication Modules, XBee
XBee Pro 60mW Wire Antenna
INTRODUCTION
This is the very popular 2.4GHz XBee XBP24-AWI-001 module from Digi (formerly known as Maxstream). The Pro series have the same pinout and command set of the basic series with an increase output power of 60mW! These modules take the 802.15.4 stack (the basis for Zigbee) and wrap it into a simple to use serial command set. These modules allow a very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! Point to point and multi-point networks are supported.SKU: WRE675 -
Communication Modules, XBee
XBee Pro 60mW PCB Antenna – Series 1
This is the very popular 2.4GHz XBee XBP24-ACI-001 module from Digi. The Pro series have the same pinout and command set of the basic series with an increase output power of 60mW! These modules take the 802.15.4 and wrap it into a simple to use serial command set. These modules allow a very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! Point to point and multi-point networks are supported.
SKU: n/a -
Communication Modules, GSM and GPS
GPS Neo 6m U-Blox NEO-6M GPS Module
- 5Hz position update rate
- Operating temperature range: -40 TO 85C UART TTL socket
- EEPROM to save configuration settings
- Rechargeable battery for Backup
- The cold start time of 38 s and Hot start time of 1 s
- Supply voltage: 3.3 V
- Configurable from 4800 Baud to 115200 Baud rates. (default 9600)
- Support SBAS (WAAS, EGNOS, MSAS, GAGAN)
- Separate GPS antenna
SKU: n/a
There are no reviews yet.