-20%
Based on 0 reviews
Be the first to review “LED 55 (RX)”
Related products
-
Accelero, Gyro. IMU, Magneto, Sensors
GY-291 ADXL345 3-Axis Accelerometer Module
- Main Chip: ADXL345
- Model: GY-291
- Power Supply: 3-5V
- Means of Communication: IIC / SPI Communication Protocol
- Measuring Range: ±2g /±16g
- Digital-Output Triple-Axis Accelerometer with a Programmable Full-Scale Range of ±2g, ±4g, ±8g and ±16g and Integrated 16-bit ADCs
- Accelerometer Normal Operating Current: 450µA
- Ultralow Power: as low as 23 μA in Measurement Mode and 0.1 μA in Standby Mode at VS = 2.5 V (typical)
- Sleep Mode Current: 8µA
- Communication: SPI (3- and 4-wire) and I2C Digital Interfaces
- User-Programmable Interrupts
- Wake-On-Motion Interrupt for Low Power Operation of Applications Processor
SKU: n/a -
Flex & Force, Sensors
Force Sensitive Resistor 0.5 INCH FSR
- Detection area (detection range): 14.5 mm circle
- Physical Diameter: 18.3mm circle
- The output signal (output signal): Passive variable to hold
- The Force-sensitive range (range), pressure test: 100g to 10 kg
- Lifespan (life):> 10 m letter actuation
Dimensions:
- Total length: 56mm
- Overall width: 18.3mm
- Diameter detection: 14.5mm
- Thickness: 0.4mm
SKU: n/a -
Others, Sensors
Microphone Amplifier – MAX9814 w/ Auto Gain Control
- The default ‘max gain’ is 60dB, but can be set to 40dB or 50dB by jumpering the Gain pin to VCC or ground.
- You can change the Attack/Release ratio, from the default 1:4000 to 1:2000 or 1:500.
- The ouput from the amp is about 2Vpp max on a 1.25V DC bias, so it can be easily used with any Analog/Digital converter that is up to 3.3V input. If you want to pipe it into a Line Input, just use a 1uF blocking capacitor in series.
SKU: n/a -
Accelero, Gyro. IMU, Magneto, Sensors
10 DOF IMU Sensor
3 Axis Accelerometer + 3 Axis Gyroscope + 3 Axis Magnetometer + Pressure Sensor on one board i.e.
ADXL 345+L3G4200D+HMC5883L+BMP085 sensors all in one board. There are also a 2.5V voltage regulator, the logic level converter circuit to make it work under the power of 3V-5V. Thanks to the logic level converter circuit, you can connect it with a 3V-5V MCU directly, just plug and play! Also every interrupt pin of the sensors is leaded out.
SKU: n/a
There are no reviews yet.