STM32
Showing all 3 results
-
Development Boards, STM32
ST Link V2 Programmer For STM8 & STM32 Microcontroller
- PCB installed inside of aluminium alloy U disk shell, portable, safe and reliable!
- The interface definition is directly marked on the shell, which is clear, convenient, and practical!
- 5V, and 3.3V offers at the same time, allowing you to program your target board with both 5V and 3.3V
- Shell characters using laser engraving, never fade off! Permanent clarity!
- 500MA internal resettable fuse, complete protection of your expensive computer motherboard!
- The Red and blue LED indicator allows you to always observe ST-LINK V2 working conditions!
- With 4 DuPont lines, you can easily respond to different target board line orders!
- Use anti-static bag packaging.
SKU: n/a -
Development Boards, STM32
STM32F4 Discovery – Arm Cortex M4 Processor kit
- STM32F407VGT6 microcontroller featuring 32-bit ARM Cortex-M4F core, 1 MB Flash, 192 KB RAM in an LQFP100 package
- On-board ST-LINK/V2 with selection mode switch to use the kit as a standalone ST-LINK/V2 (with SWD connector for programming and debugging)
- Board power supply: through USB bus or from an external 5 V supply voltage
- External application power supply: 3 V and 5 V
- LIS302DL or LIS3DSH ST MEMS 3-axis accelerometer
- MP45DT02, ST MEMS audio sensor, omni-directional digital microphone
- CS43L22, audio DAC with integrated class D speaker driver
- Eight LEDs:
- LD1 (red/green) for USB communication
- LD2 (red) for 3.3 V power on
- Four user LEDs, LD3 (orange), LD4 (green), LD5 (red) and LD6 (blue)
- 2 USB OTG LEDs LD7 (green) VBus and LD8 (red) over-current
- Two push buttons (user and reset)
- USB OTG FS with micro-AB connector
- Extension header for all LQFP100 I/Os for quick connection to prototyping board and easy probing
SKU: n/a -
Development Boards, STM32
STM32F401 F411 Black Pill Mini Development Board
- STM32F411CEU6 (100Mhz) with 512KB FLASH & 128KB RAM
- Onboard LDO for 5V to 3.3V DC conversion
- 2x 20 Pin Single Line Header which gives access to all the IOs. The board comes with unsoldered header connectors.
- The header for SWD Programming Interface
- Switches for Reset, Boot Mode, User
- LED for Power and another connected on GPIO(C13)
- 25MHZ high speed crystal, 32.768Khz low speed crystal
- BOOT0 and NRST, releasing NRST to access serial port download, and DFU download, using ST multi-in-one STM32 Cube Programmer burning software.
- Option to solder SPI Memory on the bottom side of the board.
- USB-C type Connector
SKU: n/a
