-
×
xl6009 4A DC/DC Step-Up Boost Converter
1 × ₨ 239 -
×
Ultrasonic Sensor HC-SR04
1 × ₨ 199
Subtotal: ₨ 438
-20%
Pumps, Sensors, Water, Water Pumps
Waterflow Sensor YFS101
This water flow sensor has a pinwheel sensor inside it which helps the sensor detect how much liquid has passed through it. By counting pulses from the output of the sensor water flow can be calculated. Each pulse is approximately 2.25 millimeters.
₨ 749 ₨ 936
Based on 0 reviews
Be the first to review “Waterflow Sensor YFS101”
Related products
-
-
Accelero, Gyro. IMU, Magneto, Sensors
Gy-61 Triple Axis Accelerometer Adxl335
- 3V-6V DC Supply Voltage
- Onboard LDO Voltage regulator
- Can be interfaced with a 3V3 or 5V Microcontroller.
- All necessary components are populated.
- Ultra Low Power: 40uA in measurement mode, 0.1uA in standby@ 2.5V
- Tap/Double Tap Detection
- Free-Fall Detection
- Analog output
- Build in ultra-low noise linear LDO voltage regulator
- Built-in onboard filters, which reduce noise from the motor and other high-current electronics
- All sensors connected to the I2C bus
- You can easily select two I2C addresses for MPU6050 by soldered jumper
- Power LED
- Build in Logic level converter for I2C
- Dimensions 20x16mm
- Designed for 5V logic level
SKU: n/a -
Accelero, Gyro. IMU, Magneto, Sensors
GY-273 Magneto HMC5883L
- Supply Voltage VCC: 3.3 to 6 V
- Heading Accuracy: 1 to 2
- Magnetic Field Range: -8 to +8 Gauss
- I2C Address: 0x1E (7-bit address)
- Max Data Rate: 160 Hz
- Digital Voltage Level: 3.3V
- Dimensions (excluding pins): 18.2mm (0.717) x 13.3mm (0.524) x 2.2mm (0.087)
- Weight: 0.95g (0.034oz)
SKU: n/a -
Others, Sensors
Microphone Amplifier – MAX9814 w/ Auto Gain Control
- The default ‘max gain’ is 60dB, but can be set to 40dB or 50dB by jumpering the Gain pin to VCC or ground.
- You can change the Attack/Release ratio, from the default 1:4000 to 1:2000 or 1:500.
- The ouput from the amp is about 2Vpp max on a 1.25V DC bias, so it can be easily used with any Analog/Digital converter that is up to 3.3V input. If you want to pipe it into a Line Input, just use a 1uF blocking capacitor in series.
SKU: n/a
There are no reviews yet.