100K NTC Thermistor
100K NTC Thermistor This Negative Temperature Coefficient (NTC) Thermistor varies in resistance according to temperature. It is a simple way to measure air temperature or the temperature of an adjacent device or surface. The resistance is 100K Ohms at 30C and decreases as temperature increases. It is extremely easy to interface to the analog input pins on an Arduino, Netduino, Raspberry Pi or other microcontroller (PIC, AVR, etc.), as well as an easy device to use in analog circuits.
Dimensions: 5.6mm x 3.5mm, with 27mm long leads. Specifications:
- B Constant: 4400K
- Resistance: 100,000 OHM
- Temperature: -30C to +125C
- Tolerance: 10%
TTC05104
This is a must-have part for any hobbyist or young electronics enthusiast. Its great for classroom electronics demonstrations and science fairs. This is the sensor at the heart of electric fans, microwave ovens, air conditioners, etc.
Based on 0 reviews
Be the first to review “100K NTC Thermistor”
Related products
-
Accelero, Gyro. IMU, Magneto, Sensors
GY-291 ADXL345 3-Axis Accelerometer Module
- Main Chip: ADXL345
- Model: GY-291
- Power Supply: 3-5V
- Means of Communication: IIC / SPI Communication Protocol
- Measuring Range: ±2g /±16g
- Digital-Output Triple-Axis Accelerometer with a Programmable Full-Scale Range of ±2g, ±4g, ±8g and ±16g and Integrated 16-bit ADCs
- Accelerometer Normal Operating Current: 450µA
- Ultralow Power: as low as 23 μA in Measurement Mode and 0.1 μA in Standby Mode at VS = 2.5 V (typical)
- Sleep Mode Current: 8µA
- Communication: SPI (3- and 4-wire) and I2C Digital Interfaces
- User-Programmable Interrupts
- Wake-On-Motion Interrupt for Low Power Operation of Applications Processor
SKU: n/a -
-
Gas Sensor, Sensors
MQ2 MQ-2 SMOKE SENSOR MODULE
- Operating voltage: 5V
- Analog output voltage: 0V to 5V
- Digital output voltage: 0V or 5V (TTL Logic)
- Preheat duration: 20 seconds
- Sensitivity range: 200 to 10,000 ppm
- Gases detected: LPG, Smoke, Alcohol, Propane, Hydrogen, Methane and Carbon Monoxide
- Dimensions: 3.6 x 2 x 1 cms
- Weight: 5 grams
SKU: n/a -
Accelero, Gyro. IMU, Magneto, Sensors
Gy-61 Triple Axis Accelerometer Adxl335
- 3V-6V DC Supply Voltage
- Onboard LDO Voltage regulator
- Can be interfaced with a 3V3 or 5V Microcontroller.
- All necessary components are populated.
- Ultra Low Power: 40uA in measurement mode, 0.1uA in standby@ 2.5V
- Tap/Double Tap Detection
- Free-Fall Detection
- Analog output
- Build in ultra-low noise linear LDO voltage regulator
- Built-in onboard filters, which reduce noise from the motor and other high-current electronics
- All sensors connected to the I2C bus
- You can easily select two I2C addresses for MPU6050 by soldered jumper
- Power LED
- Build in Logic level converter for I2C
- Dimensions 20x16mm
- Designed for 5V logic level
SKU: n/a
There are no reviews yet.