“Force Sensitive Resistor 0.5 INCH FSR” has been added to your cart. View cart
Related products
-
Accelero, Gyro. IMU, Magneto, Sensors
GY-291 ADXL345 3-Axis Accelerometer Module
0 out of 5(0)- Main Chip: ADXL345
- Model: GY-291
- Power Supply: 3-5V
- Means of Communication: IIC / SPI Communication Protocol
- Measuring Range: ±2g /±16g
- Digital-Output Triple-Axis Accelerometer with a Programmable Full-Scale Range of ±2g, ±4g, ±8g and ±16g and Integrated 16-bit ADCs
- Accelerometer Normal Operating Current: 450µA
- Ultralow Power: as low as 23 μA in Measurement Mode and 0.1 μA in Standby Mode at VS = 2.5 V (typical)
- Sleep Mode Current: 8µA
- Communication: SPI (3- and 4-wire) and I2C Digital Interfaces
- User-Programmable Interrupts
- Wake-On-Motion Interrupt for Low Power Operation of Applications Processor
SKU: n/a -
Pressure, Sensors
BMP180 – Atmospheric Pressure Sensor
0 out of 5(0)- 1.8V to 3.6V Supply Voltage
- Low power consumption 0.5uA at 1Hz
- I2C interface
- Max I2C Speed: 3.5Mhz
- Very low noise up to 0.02hPa (17cm)
- Full calibrated
- Pressure Range: 300hPa to 1100hPa (+9000m to -500m)
- Weight: 1.18g
- Size: 21mm x 18mm
SKU: n/a -
Accelero, Gyro. IMU, Magneto, Sensors
Gy-61 Triple Axis Accelerometer Adxl335
0 out of 5(0)- 3V-6V DC Supply Voltage
- Onboard LDO Voltage regulator
- Can be interfaced with a 3V3 or 5V Microcontroller.
- All necessary components are populated.
- Ultra Low Power: 40uA in measurement mode, 0.1uA in standby@ 2.5V
- Tap/Double Tap Detection
- Free-Fall Detection
- Analog output
- Build in ultra-low noise linear LDO voltage regulator
- Built-in onboard filters, which reduce noise from the motor and other high-current electronics
- All sensors connected to the I2C bus
- You can easily select two I2C addresses for MPU6050 by soldered jumper
- Power LED
- Build in Logic level converter for I2C
- Dimensions 20x16mm
- Designed for 5V logic level
SKU: n/a -
Others, Sensors
Microphone Amplifier – MAX9814 w/ Auto Gain Control
0 out of 5(0)- The default ‘max gain’ is 60dB, but can be set to 40dB or 50dB by jumpering the Gain pin to VCC or ground.
- You can change the Attack/Release ratio, from the default 1:4000 to 1:2000 or 1:500.
- The ouput from the amp is about 2Vpp max on a 1.25V DC bias, so it can be easily used with any Analog/Digital converter that is up to 3.3V input. If you want to pipe it into a Line Input, just use a 1uF blocking capacitor in series.
SKU: n/a
Zonex Super Glue
Mini Magnifying Glass with Illuminant
Force Sensitive Resistor 0.5 INCH FSR 





There are no reviews yet.