Accelero, Gyro. IMU, Magneto
Showing all 5 results
-
Accelero, Gyro. IMU, Magneto, Sensors
10 DOF IMU Sensor
3 Axis Accelerometer + 3 Axis Gyroscope + 3 Axis Magnetometer + Pressure Sensor on one board i.e.
ADXL 345+L3G4200D+HMC5883L+BMP085 sensors all in one board. There are also a 2.5V voltage regulator, the logic level converter circuit to make it work under the power of 3V-5V. Thanks to the logic level converter circuit, you can connect it with a 3V-5V MCU directly, just plug and play! Also every interrupt pin of the sensors is leaded out.
SKU: n/a -
Accelero, Gyro. IMU, Magneto, Sensors
GY-273 HMC5883L Triple-axis Magnetometer Compass Module
- Type: GY-271
- Operating Voltage : 3 -5 V DC.
- Chipset: HMC5883L.
- Communication: I2C protocol.
- Measuring range: ± 1.3-8 Gauss.
- Dimensions : 14.8 x 13.5 x 3.5 mm.
- Weight: 2 gm.
- 3-axis magnetic electronic compass.
- Precise heading information.
- Fits into small projects easily.
- I2C communication.
SKU: n/a -
Accelero, Gyro. IMU, Magneto, Sensors
Gy-61 Triple Axis Accelerometer Adxl335
- 3V-6V DC Supply Voltage
- Onboard LDO Voltage regulator
- Can be interfaced with a 3V3 or 5V Microcontroller.
- All necessary components are populated.
- Ultra Low Power: 40uA in measurement mode, 0.1uA in standby@ 2.5V
- Tap/Double Tap Detection
- Free-Fall Detection
- Analog output
- Build in ultra-low noise linear LDO voltage regulator
- Built-in onboard filters, which reduce noise from the motor and other high-current electronics
- All sensors connected to the I2C bus
- You can easily select two I2C addresses for MPU6050 by soldered jumper
- Power LED
- Build in Logic level converter for I2C
- Dimensions 20x16mm
- Designed for 5V logic level
SKU: n/a -
Accelero, Gyro. IMU, Magneto, Sensors
GY521 MPU6050 3 Axis Digital Gyroscope Accelerometer Sensor Module
Accelero, Gyro. IMU, Magneto, SensorsGY521 MPU6050 3 Axis Digital Gyroscope Accelerometer Sensor Module
A 3-axis gyroscope and a 3-axis accelerometer are combined together on the same silicon die with an onboard Digital Motion Processor. Easy to get it fit into your project! It is very accurate, as GY-521 Mpu6050 Module contains 16-bits analog to digital conversion hardware for each channel. Therefor Three axis Gyrometer captures the x, y, and z channel at the same time. The sensor uses the I2C-bus to interface with the Arduino.
SKU: n/a -
