-
×
Ultrasonic Sensor HC-SR04
1 × ₨ 199 -
×
MQ2 MQ-2 SMOKE SENSOR MODULE
1 × ₨ 289
Subtotal: ₨ 488
-20%
Based on 0 reviews
Be the first to review “LED 55 (RX)”
Related products
-
Accelero, Gyro. IMU, Magneto, Sensors
10 DOF IMU Sensor
3 Axis Accelerometer + 3 Axis Gyroscope + 3 Axis Magnetometer + Pressure Sensor on one board i.e.
ADXL 345+L3G4200D+HMC5883L+BMP085 sensors all in one board. There are also a 2.5V voltage regulator, the logic level converter circuit to make it work under the power of 3V-5V. Thanks to the logic level converter circuit, you can connect it with a 3V-5V MCU directly, just plug and play! Also every interrupt pin of the sensors is leaded out.
SKU: n/a -
Current & Voltage, Sensors
ACS712 Current Sensor 30A
ACS712 Current Sensor 30A current sensor board is based on the Allegro ACS712ELCTR-30A bi-directional hall-effect current sensor chip that detects positive and negative flowing currents in the range of minus 30 Amps to positive 30 Amps. The board operates at 5V DC and the current flow through the sensor is converted to an output voltage starting at 1/2Vcc (or 2.5V) for no current flow and moves up 66mV per amp for positive current or down -66mV per amp for negative current.
SKU: n/a -
Heart Rate And Muscle Sensors, Sensors
Biomedical Sensor Pad (10 pack)
This is a 10 pack of Biomedical Sensor Pads, disposable electrodes that can be used to measure EEG, ECG and EMG levels. these little pads are perfect for short-term monitoring of Neurofeedback and Biofeedback purposes. They are to be used once and are very handy because of integrated, latex-free gel. Each pad adheres very well to the skin and the snap connector can be pushed on or removed from the electrode lead with no issue.
SKU: n/a -
Accelero, Gyro. IMU, Magneto, Sensors
Gy-61 Triple Axis Accelerometer Adxl335
- 3V-6V DC Supply Voltage
- Onboard LDO Voltage regulator
- Can be interfaced with a 3V3 or 5V Microcontroller.
- All necessary components are populated.
- Ultra Low Power: 40uA in measurement mode, 0.1uA in standby@ 2.5V
- Tap/Double Tap Detection
- Free-Fall Detection
- Analog output
- Build in ultra-low noise linear LDO voltage regulator
- Built-in onboard filters, which reduce noise from the motor and other high-current electronics
- All sensors connected to the I2C bus
- You can easily select two I2C addresses for MPU6050 by soldered jumper
- Power LED
- Build in Logic level converter for I2C
- Dimensions 20x16mm
- Designed for 5V logic level
SKU: n/a
There are no reviews yet.